Is it necessary to punch solidcore skirtings?
What causes stress whitening and how can I remove it?
The lower lip of the S60 and also the C60 folds upwards when forming outside corners – how can I prevent this?
After punching the outside corner, place the skirting on the floor and carefully slide into position.
Click here for the S 60 installation instructions.
What is the specified nailing pitch for solidcore skirtings?
The fastener spacing must take into account the condition of the wall (unevenness, indentations etc.); permanent attachment to the wall must be guaranteed. The S 60 flex life, TS 60 life, C 60 life and D 60 life Top may ideally be nailed at 60 cm max. pitch.
The ideal max. fastening pitch for the S 100 life, TS 100 life, C 100 life and the S 40/22, S 66/22 and the EP 60/13 flex life is 25 cm.
The fastener distance to corners and butt joints should not exceed 5 cm.
Click here for installation instructions.
Can I punch corners with a 90° angle?
Place the profile into the punch upside down, so that the top will face downwards like when punching the outside corner.
Punch only the core - not the top. Install the profile around the corner. Then, for inside corners, cut the floor side lip, for outside corners cut the wall side lip. See also EP installation video.
Can I insert a cable into TS60 carpet solidcore skirtings?
How thick and wide can the D60 cover strip be ?
How thick and wide can the C60 and C100 cover strips be?
Are there end caps for the EP60/13 and Cubu flex life profiles? How can I make end caps?
Why should carpet strips not properly attach in the carpet solidcore skirtings?
It is advisable for carpet backs with little adhesion surface or special textures (felt, Velcro, fleece or woven back) or where carpet backs have PVC softeners or separating agents to also paint the carpet back with a suitable adhesive or to glue a suitable dry adhesive strip to the body of the carpet skirting before fitting the carpet strip and fastening it along its entire length. Always also take note of instructions by the manufacturers of the flooring and the adhesive. It is also possible to use the TS60 solidcore skirting in white and not use the factory fitted dry adhesive strip.